standard temperature

1. This actuator is used only on models equipped with the standard manual temperature control system.
   这种引动器仅用于装有标准手动温度控制系统的车型。
2. Light design, which did not require external temperature of the console, equipped with three standard temperature control-360 ℃, 390 ℃, 420 ℃.
   轻便式设计，无需接驳温度控制台，配备三个标准温度调节钮-360℃，390℃，420℃。
3. Conditioning textile samples to a standard temperature and moisture content is critical prior to color measurement.
   测色前将纺织试样调节到标准温、湿度很重要。
4. Design of In-situ K-type Standard Temperature Sensor Based on Two-shielded Blowing Thermocouple
   基于双屏吹气偶的现场K型参考温度传感器设计
5. NBR rubber O-rings provide trouble-free operation at standard temperature ranges. For high and low temperature applications Viton or Silicone.
   在常温工作条件下使用丁腈橡胶，在高温或低温时采用氟橡胶或硅橡胶。
6. The temperature model can be used to the determination of standard temperature of stator iron-core on various operating conditions in order to monitor generator operating and diagnosis faults.
   利用辨识得到的定子铁心温度模型即可计算发电机在各种正常运行状态下定子铁心温度的标准值，以实现发电机的状态监测和早期故障诊断。
7. Determination of standard temperature of stator winding in different operating states for turbogenerator fault diagnosis
   发电机故障诊断中不同运行条件下定子绕组温度标准值的确定
8. The results show that the asymmetry of temperature field in detection equipment is influenced by super temperature in natural environment, and the standard temperature sensor and the ones regulated are not installed appropriately in the temperature equipment.
   结果表明：造成校准超差的直接原因是自然环境温度过高引起温度校准设备内的温度分布不均匀，间接原因是标准温度传感器与被校准温度传感器在温度槽内不恰当的安装。
9. This system is calibrated using a blackbody furnace as standard temperature source. The relationship between flame temperatures and grey level of the images is established through image processing and function correlation.
   借助黑体炉等标定源，利用温控系统提供温度参数，经CCD系统成像得到图像的灰度值，通过函数拟合获得辐射图像灰度与温度之间的关系。
10. Humidity was higher than standard and temperature is lower in ventilated henhouse, when the temperature of environment is lower.
    在外界环境温度较低时，自然通风鸡舍内湿度大、温度低，在低温下，高湿度会造成饲料利用率下降，因此需要调整鸡舍内温、湿度。
11. Determination on Stator Standard Temperature in Condition Monitoring of Turbogenerators
    汽轮发电机状态监测中定子温度标准值的确定
12. The friction behavior of three kinds of graphite used for nuclear reactors was tested by SRV standard high temperature friction tester under the helium and air environments The friction coefficients for the three kinds of graphite all increase with the friction speed increases.
    在高温摩擦实验机SRV上对三种反应堆用石墨的摩擦系数进行了测试，实验条件分别是高温气冷堆冷却剂氦气环境和空气环境。
13. It require high standard of temperature and humidity.
    他对房间的温度和湿度有很高的要求。
14. In thermal state monitoring of generators, the temperature model parameters need to be determined firstly in order to obtain the standard temperature value of generator stator end region ( SER).
    在发电机的热状态监测中，为了确定汽轮发电机定子铁心端部温度的标准值，必须首先确定温度模型中的各个参数。
15. This paper introduces that the temperature measured in the thermocouple was calibrated by the temperature measured in higher precise mercury thermometer regarded as the standard temperature, and presents the method of the establishment of revised formula by the Least Squares Method.
    本文介绍了用高精度的水银温度计测得的温度作为标准温度，来校准热电偶的测温结果，并用最小二乘法来拟合其修正公式的方法。
16. This paper concerns the optimal standard of temperature during the reaction process and investigates the rate-determining step in the reaction process.
    本文研究了反应过程的最优温度规范，并探讨反应过程的控制步骤。
17. On the Standard of Temperature and moisture Inside the Cold Rolling Mill In Winter
    冷轧厂冬季室内空气温、湿度标准的探讨
18. In Excel, one of the main document to complete the standard temperature acquisition device and another document is used to collect data from equipment which is calibrated, and the original data.
    在Excel中，其中一个文档主要完成对标准器的温度采集，另一个文档主要针对不同的被校准设备编制数据采集表和原始数据表；下位机程序使用了C语言。
19. By simulating the scene of a fire temperature according to the ISO standard temperature elevation curve and temperature field distribution of reinforced concrete slabs under high-temperature conditions with the finite element software, different temperature curves that are apart from the fire surface have been presented in this thesis.
    按ISO标准升温曲线模拟火场温度，通过有限元软件模拟板在高温下的温度场分布，绘制出板截面上距受火面不同高度的升温曲线。
20. It forms solid grey crystals at standard temperature and pressure, is highly toxic and radiation hazard.
    在标准温度和压力下，形成坚实的灰色晶体，有较高的化学毒性，还具有辐射危害。
21. A device, based on cantilever method, was built to test bending stiffness. The relevance of the bending stiffness measured by device and KES was discussed by comparative experiments in standard temperature and humidity.
    本文基于斜面法原理搭建出测试织物弯曲刚度Bz的装置，通过标准温湿度下的对比实验讨论了斜面法测得的弯曲刚度Bz与KES弯曲刚度Bk的相关性。
22. To a certain catalyst, after determining the optimum chlorine content, the water-chlorine molecular ratios at the standard temperature and the reaction temperature can be confirmed.
    而对一定的催化剂，当确定了最佳氯含量以后，就可以确定其对应的标准温度下的水氯分子比。
23. In order to ISO-834 standard temperature-time to curve simulated fire ( high temperature), temperature calculation and mechanical analysis using the three-dimensional coupled thermo-mechanical unit of the large-scale finite element analysis software ANSYS.
    以ISO-834标准温度&时间曲线模拟火灾（高温），采用大型有限元分析软件ANSYS中的三维热力耦合单元进行温度计算和力学分析。
24. In this paper, based the standard effective temperature SET as the thermal comfort control index, a test controller of the single air-conditioning, ceiling fan and windows three coordinated control was studied to make indoor thermal environment of the SET value in a comfortable range.
    本文以标准有效温度SET为热舒适控制指标，研究了一个实现单体空调、吊扇和窗户三者联动控制的实验控制器，使室内热环境的SET值处于舒适的范围之内。
25. The relevance of the Shear angle y and shearing stiffness measured by KES was discussed by comparative experiments in standard temperature and humidity. ( 4) Bending and shearing properties of fabrics were studied in the extremely cold environment.
    通过标准温湿度下的对比实验，讨论了定负荷下测得的剪切角γ与KES测得的剪切刚度G的相关性，并作评价（4）低温下织物的弯曲和剪切性能测试研究。
26. By simulating the scene of a fire temperature according the ISO standard temperature elevation curve. Temperature change analysis of prestressed concrete simple slab subjected to fire is carried out by using of ANSYS software.
    按标准升温曲线模拟温度，通过应用ANSYS软件实现对预应力混凝土单向简支板的温度变化全过程分析。
27. The whole test process is undertaken in the modeled standard temperature curve. The result of the test demonstrates that the properties of the furnace are stable and convenient for use.
    火灾试验使用的试验炉为自行研制的燃油火灾试验炉，全部的试验是在模拟标准升温曲线的基础上进行的，试验结果表明炉子性能稳定、使用方便。

noun

1. exactly zero degrees centigrade